MIDI Phat

Comments (9)

• davidb63 · March 03 2014
  Looks great! Can this be used along side the moog editor? I'm assuming the moog editor will still be required to save patches with projects?
• Telegraph909 · March 06 2014
  Hi davidb63,
  I've used the Moog editor and MIDI Phat along side each other a few times but you need to use the Moog editor as standalone. It won't work on the same track in Live. As for patches, they will be saved with your Live project and can be saved as presets by clicking the disk icon in the title bar. You can click Send to Phatty to transfer your patch to the Sub Phatty, but you must use the Moog editor librarian to save patches inside the Sub Phatty. Hope that answers your questions.
• davidb63 · March 15 2014
  Hi, I tried saving a test project with the midi phat2 on a midi channel and it didn't save the preset. I recorded a small midi clip with a specific setting dialed in the moog.. saved it, then closed it. Then moved the dials around on the moog.. and loaded the project back up. The patch was recalled. Was I missing something?
• Telegraph909 · March 17 2014
  Hi davidb63,
  I was not able to reproduce your problem. Which version of Live/Max are your using? You can also send me your project so I can look into this problem. My email is den (dot) d (at) live (dot) ca.
• davidjames · May 06 2014
  Hi, does this device allow me to use the knobs on the SP to record automation data in the arrangement view? Currently this is not working using the VST editor, I can only record CC data to the clip.
• Telegraph909 · May 08 2014
  Hi davidjames,
  You should be able to record automation in arrangement view even without any VST editor or my patch. Double check your Live MIDI preferences and make sure the track is armed.
• davidjames · December 01 2014
  Hi Telegraph,
  I am trying to midi map the controls so I don't need to be record armed to use the SP knobs. So far so good except the LFO Source switch and the OSC 1 and OSC 2 Octave switches. I get erratic behavior usually landing on the wrong setting. Probably not a coincidence these are not typical knobs or buttons, but do you have any advice on how to map those? I'm on Ableton 9.1.6 on a OSX 10.8.5. Thanks!
• davidjames · December 11 2014
  Hey Denis,
  Great work on MidiPhat2.0! It's working well with my setup. One question though. I have the parameters mapped to my midi fighter twister and I'm recording automation. The automation lane in the arrange view is very zoomed in and I can't figure out how to make it look like a normal automation window. I'm attaching a screenshot which illustrates what is happening. Someone on a forum mentioned changing the parameter type from "int" to "float". I'm not very fluid in maxforlive programming, does that make sense to you and would it be a hard change to make?
  Thanks for your time.
• gooz · June 03 2015
  hi denis!
  first of all thanks for your great work, it controls well my moog subphatty!
  One question though, I can't get midi from my moog, with the button on the right.
  How does this features work?
  thanks a lot
  regards
  gooz