Description

This Device Controls the Stereoping Synth Controller with the DW8000 Firmware. This is NOT a controller itself for the DW8000, only for the Stereoping controller, to do automations, etc.

I guess it explains itself, knobs sending CC Values, and bit of hiding action for the three modes.

The BP Link (or Breakpoint Link) links the Sustain and Breakpoint Values, thus disabling the breakpoint and giving you normal ADSR Control. While linked, Slope is disabled.

If you want to use this for a different Stereoping Controller Firmware, you could just rename a few knobs (and rearrange them in the "all" mode.

Note: The "All" Mode uses a different set of linked knobs, so if you automate stuff do it either in the "All" page or on the "R/G/B" pages.

Have Fun!